implementing load balancing through IS-IS: Networking Requirements As shown in Figure 1: CX- A, CX- B, CX- C, and CX- D run IS-IS to implement interconnection in the IP network. CX- A, CX- B, CX- C, and CX- D are Level-2 routers in area 10. Load balancing is required to transmit the traffic of CX- A to CX- D through CX- B and CX- C. Figure 1 Networking diagram of configuring IS-IS load balancing Device Interface IP Address Device …
Continue reading Configuring IS-IS Load BalancingAugust 2015
You are browsing the site archives for August 2015.
Protocol Load Balancing Equal-cost load balancing The CX600 supports multi-route mode. You can configure multiple routes with the same preference to the same destination. If there are no other routes with higher priorities to the target destination, these “equal-cost” routes are used. Packets transmitted to the target destination are sent along different routes and, in this way, …
Continue reading Basic Principles of Load Balancing