implementing load balancing through IS-IS: Networking Requirements As shown in Figure 1: CX- A, CX- B, CX- C, and CX- D run IS-IS to implement interconnection in the IP network. CX- A, CX- B, CX- C, and CX- D are Level-2 routers in area 10. Load balancing is required to transmit the traffic of CX- A to CX- D through CX- B and CX- C. Figure 1 Networking diagram of configuring IS-IS load balancing Device Interface IP Address Device …
Continue reading Configuring IS-IS Load BalancingLoad Balancing
Protocol Load Balancing Equal-cost load balancing The CX600 supports multi-route mode. You can configure multiple routes with the same preference to the same destination. If there are no other routes with higher priorities to the target destination, these “equal-cost” routes are used. Packets transmitted to the target destination are sent along different routes and, in this way, …
Continue reading Basic Principles of Load BalancingConfiguring Load Balancing Among EBGP and IBGP Routes When CEs Are Dual-Homed When a CE is dual homed to two PEs, if one PE is in the same AS as the remote PE, whereas the other PE is not in the same AS as the remote PE, you can configure EBGP and IBGP route load …
Continue reading Configuring Load Balancing Among EBGP and IBGP Routes When CEs Are Dual-Homed